You may be able to use regular wood glue or polyurethane glue. Let us know how it works out. A 1:8 scarf should give you enough surface area. If you switch back to epoxy, wet each surface with unthickened epoxy, then mix-in some cabosil to thicken it, coat each surface with a thin coat and clamp gently. You don't want to squeeze-out all the thickened epoxy, so you'll have to use a light touch on the narrow strips.

Good luck!

Ross

> I know others must have had a similar situation. I need to scarf 1/4"
> x 3/16" red wood strips together and I can not get a good stable
> scarf.

> This is what I have tried so far.

> ? A fresh cut then with MAS slow cure epoxy

> ? A fresh cut with 5-min epoxy

> I have not tried use wood glue yet (tonight?).

> With MAS epoxy the next day the joint was completely unattached (I think
> MAS is just to thin and penetrated into the wood and there was not enough
> epoxy left for the joint.

> With 5 min epoxy, the epoxy was nice and thick and stayed with the joint.
> But when I removed the clamps this morning one of the joints broke. I
> think 5-min epoxy is just to stiff and will not give. I did not have the
> time this morning to check the strength of the other scarf joints.

> I need a good strong joint because the scarf will be on a tight curve (I
> am planning on construction with no staples). Does anyone have any
> suggestions about to create such a strong scarf joint for such an
> application.

> I am thinking that I need to create more surface area for the glue to
> adhere to. However I fear making the scarf joints any longer, for when I
> bend the strips in my bending/glue up mold the section by the scarf will
> not bend like the rest of the wood.

> Jason