Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: I second Tim's question...thanks Kent...
By:Don Lucas
Date: 2/7/2003, 9:28 am
In Response To: I second Tim's question...thanks Kent... *NM* (Bob Deutsch)

I used B&C strips on the hull of and turned to the rolling on the deck. I belived it save time and is much better for your head, very zen, the block plane. I slightly over beveled and used 4 oz glass and it is the strongest deck I have put my 200 lbs on. I also do not have a foward bulkhead.
Don

Messages In This Thread

Strip: trouble with b&c routing
Pascal, in Chile -- 2/6/2003, 10:21 am
Re: Strip: trouble with b&c routing
David Hanson -- 2/6/2003, 4:40 pm
b&c vs bevel
mike allen -- 2/7/2003, 9:13 pm
Re: Strip: trouble with b&c routing
Mike Loriz -- 2/6/2003, 3:12 pm
Re: Strip: trouble with b&c routing *LINK* *Pic*
Kurt Loup, Baton Rouge -- 2/6/2003, 1:49 pm
Thanks everyone, this ought to work ... *LINK*
Pascal, in Chile -- 2/6/2003, 3:30 pm
Re: Thanks everyone, this ought to work ...
Kurt Loup, Baton Rouge -- 2/6/2003, 4:49 pm
Re: Strip: trouble with b&c routing
Paul J -- 2/6/2003, 1:40 pm
Re: Strip: trouble with b&c routing *Pic*
Chip Sandresky -- 2/6/2003, 12:18 pm
Re: Strip: trouble with b&c routing
Tim Eastman -- 2/6/2003, 1:04 pm
Re: Strip: trouble with b&c routing
Chip Sandresky -- 2/6/2003, 2:16 pm
Re: Strip: trouble with b&c routing
Kent LeBoutillier -- 2/6/2003, 11:39 am
Re: Strip: trouble with b&c routing
Tim Eastman -- 2/6/2003, 12:56 pm
Re: Strip: trouble with b&c routing
Kent LeBoutillier -- 2/7/2003, 6:22 am
My turn for a stupid question....
Bob Deutsch -- 2/7/2003, 12:06 pm
Re: My turn for a stupid question....
Kent LeBoutillier -- 2/7/2003, 9:42 pm
If I might explain beveling
Paul G. Jacobson -- 2/7/2003, 12:20 am
Re: If I might explain beveling
Bob Deutsch -- 2/7/2003, 4:29 am
Re: If I might explain beveling
Jack Sanderson -- 2/7/2003, 10:31 am
Thanks Sam & Jack! *NM*
Bob Deutsch -- 2/7/2003, 12:08 pm
Re: If I might explain beveling
Sam McFadden -- 2/7/2003, 10:30 am
Re: If I might explain beveling
Mike Loriz -- 2/7/2003, 7:57 pm
Re: If I might explain beveling
Sam McFadden -- 2/7/2003, 11:17 pm
Re: If I might explain beveling
Mark Normand -- 2/7/2003, 7:11 am
I second Tim's question...thanks Kent... *NM*
Bob Deutsch -- 2/6/2003, 3:19 pm
Re: I second Tim's question...thanks Kent...
Don Lucas -- 2/7/2003, 9:28 am