Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: too tight
By:lee
Date: 7/12/1999, 11:16 am
In Response To: Beaut! (mike allen)

when I made the foam mold. I was wearing my wet suit and a pair of seat pants.

When cleaning up and sanding the mold there is a lot of foam that had to be taken away from between the thighs and behind the tail bone. The idea was to make the mold big enough for me to slide into and pad with 1/8-1/4 neoprene if needed.

Messages In This Thread

custom form-fit seating
Chris Kohut -- 7/5/1999, 7:52 am
Re: custom seating - heat molded plastic?
Hank -- 7/7/1999, 3:16 pm
Re: custom form-fit seating
lee -- 7/7/1999, 2:55 pm
Re: custom form-fit seating
lee -- 7/7/1999, 2:58 pm
Beaut!
mike allen -- 7/7/1999, 8:13 pm
Re: too tight
lee -- 7/12/1999, 11:16 am
but, but , butt.....
Paul G. Jacobson -- 7/10/1999, 7:47 pm
how about some brand names & dealers ?
erez -- 7/6/1999, 10:04 pm
Re: how about some brand names & dealers ?
Paul G. Jacobson -- 7/7/1999, 4:27 am
Re: custom form-fit seating
Berkeley C. -- 7/6/1999, 3:54 pm
Re: custom form-fit seating
mike allen -- 7/6/1999, 5:14 pm
Re: custom form-fit seating
Berkeley C. -- 7/6/1999, 6:10 pm
Re: custom form-fit seating
mike allen -- 7/6/1999, 6:51 pm
Re: custom form-fit seating
Paul G. Jacobson -- 7/7/1999, 3:57 am
Re: custom form-fit seating
Ed Valley -- 7/14/1999, 2:48 pm
Makes Sense
mike allen -- 7/7/1999, 1:29 pm
Re: custom form-fit seating
Paul G. Jacobson -- 7/5/1999, 9:43 pm