Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: 90 degree corners
In Response To: Re: S&G: 90 degree corners ()

: Glass the bulkhead side first allowing the glass to be all the way
: to the edge if not over a little. Wait for full cure, sand back
: edge of glass to the edge of bulkhead, then glass the outside of
: the boat over the edge of the bulkhead leaving glass sticking
: out further. Again wait for full cure sand back and wala done.
: This will take a while with epoxy and it will rely on a
: mechanical bond at the edge but it will be a clean look on the
: outside of the boat.

This sounds like an excellent idea. Remember that the glass provides strength and impact resistence but waterproofing comes from the resin. As long as you have plenty of resin in the edge, water shouldn't seep in.