: The strip looks great, but I hope you plan to install it in area with few
: bends - It looks like it could be a little fragile. Is there any way you
: could build the strip in-place on the boat? I did that on the deck of my
: Outer Island and it worked great. It was still a lot of individual piece
: fitting, but the end result conforms exactly to the curves of the boat.

: Good luck,

: Ross

Hi Ross,

I remember asking you if you built it in one piece and then gluing it into your boat and you telling me you built it in place. It's too bad chip didn't see your answer before he built his.

Chip, if you used yellow glue, perhaps you could soak the strip in water until it came apart and then reglue the pieces inplace like Ross did.

John