Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Poor man's power feed
By:Geo. Cushing
Date: 4/4/2001, 11:42 am
In Response To: power feed (Russell Brown)

: I am trying to find a source for a power feed for my router table that
: can be used on the table saw as well. Help!

Russ,
If you have a thickness planer with its own feed you can gang your planing and routing operation. I think Chris Kulczycki's "From the Kayak Shop" shows such a set up. If you don't have a thickness planer, I'd recommend Matkita's new model. It's priced lower than a good feeder and to my mind a better purchase than the feeder.
Geo. C.

Messages In This Thread

power feed
Russell Brown -- 4/3/2001, 11:44 pm
Re: Poor man's power feed
Geo. Cushing -- 4/4/2001, 11:42 am
Re: Poor man's power feed
Russell Brown -- 4/4/2001, 5:25 pm
Re: Poor man's power feed
Nick Schade - Guillemot Kayaks -- 4/5/2001, 9:26 am
Re: power feed
Nick Schade - Guillemot Kayaks -- 4/4/2001, 9:12 am
Hmm, it's not supposed to double post
Nick Schade - Guillemot Kayaks -- 4/4/2001, 1:56 pm
Re: Oh, I thought you were suggesting...
Ross Leidy -- 4/4/2001, 1:59 pm
Re: power feed
Nick Schade - Guillemot Kayaks -- 4/4/2001, 9:08 am
Re: power feed
kurt -- 4/3/2001, 11:52 pm
Re: power feed
Russell Brown -- 4/4/2001, 12:10 am
Re: power feed
mark Shiner -- 4/4/2001, 12:12 am
Re: power feed
Russell Brown -- 4/4/2001, 12:26 am
Re: power feed
Kurt -- 4/4/2001, 10:44 am
Re: power feed
Rob Macks -- 4/4/2001, 11:10 am
Re: power feed
Nick Schade - Guillemot Kayaks -- 4/4/2001, 2:09 pm
Re: power feed
Rehd -- 4/4/2001, 2:12 am
Re: power feed
Simon Baillie -- 4/4/2001, 9:09 am
Re: power feed
Rehd -- 4/4/2001, 9:52 am
Re: power feed
Simon Baillie -- 4/4/2001, 4:53 pm
Re: Board Straightener *Pic*
Rehd -- 4/4/2001, 11:32 pm