Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: designing using cad
By:Grant Goltz
Date: 3/17/2000, 11:48 am
In Response To: Re: designing using cad (pete czerpak)

> try www.carlsondesign.com

> hope it helps. i tried playing around with it. seems fairly powerful for
> looking at hull designs.

> regards, Pete albany, NY

This works quite well. However, if you are doing a S&G and you have the design pretty well tweaked, I highly recommend the Unfold software by Doug Garmon. Cut your panels carefully and the yak literally falls together with no adjustments needed. This is what I used for the Cormorant offsets on our site.

Grant

Unfold Home Page

Messages In This Thread

designing using cad
Bryan Gleason -- 3/15/2000, 6:28 pm
Re: designing using cad
Eric Schade (shearwater Boats) -- 3/17/2000, 7:17 pm
Re: designing using cad
Leroy Laskowski -- 3/20/2000, 8:28 pm
Re: designing using cad
Eric Schade (shearwater Boats) -- 3/21/2000, 6:50 am
Re: designing using cad
Leroy Laskowski -- 3/20/2000, 8:24 pm
Re: designing using cad
pete czerpak -- 3/16/2000, 12:32 pm
Re: designing using cad
Grant Goltz -- 3/17/2000, 11:48 am
Re: designing using cad
pete czerpak -- 3/17/2000, 12:05 pm
Re: designing using cad
Grant Goltz -- 3/17/2000, 12:19 pm
Re: designing using cad
Scotty -- 3/16/2000, 1:07 pm
Re: designing using cad
Hans Friedel -- 3/17/2000, 4:13 pm
Re: designing using cad
pete czerpak -- 3/17/2000, 7:48 am
Re: designing using cad
pete czerpak -- 3/16/2000, 12:29 pm
Re: designing using cad
Hans Friedel -- 3/16/2000, 12:52 am
Re: Where's Mark...
Scotty -- 3/16/2000, 12:39 am
Re: Where's Mark...
pete czerpak -- 3/16/2000, 12:33 pm