Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Simple scarfing jig for handplanes
By:Matt Jakubek
Date: 4/30/2013, 8:40 am
In Response To: Re: Strip: Simple scarfing jig for handplanes (Kevin)

I guess the knob and the across strip hold down the strips to plane. What is the angle/ratio on the jig?

yes, the knob holds down the strip, holding it by hand was impossible. the angle is 6°, so that's pretty flat and gives you a paper-like ending.

Messages In This Thread

Strip: Simple scarfing jig for handplanes *PIC*
Matt Jakubek -- 4/30/2013, 8:12 am
Re: Strip: Simple scarfing jig for handplanes
Kevin -- 4/30/2013, 8:37 am
Re: Strip: Simple scarfing jig for handplanes
Matt Jakubek -- 4/30/2013, 8:40 am
Re: Strip: Simple scarfing jig for handplanes *PIC*
ancient kayaker -- 4/30/2013, 10:53 am
Re: Strip: Simple scarfing jig for handplanes *PIC*
ancient kayaker -- 4/30/2013, 10:54 am
Re: Strip: Simple scarfing jig for handplanes
Matt Jakubek -- 4/30/2013, 11:10 am
Re: Strip: Simple scarfing jig for handplanes
ancient kayaker -- 5/1/2013, 12:17 am
Re: Strip: Simple scarfing jig for handplanes
Deano -- 5/1/2013, 8:29 am
Re: Strip: Simple scarfing jig for handplanes
Matt Jakubek -- 5/1/2013, 8:38 am
Re: Strip: Simple scarfing jig for handplanes
Jeff Horton -- 4/30/2013, 10:58 am
Re: Strip: Simple scarfing jig for handplanes
Brian Nystrom -- 5/1/2013, 7:25 am
Re: Strip: Simple scarfing jig for handplanes
Matt Jakubek -- 5/1/2013, 8:31 am
Re: Strip: Simple scarfing jig for handplanes
Bill Hamm -- 5/5/2013, 1:11 am
Re: Strip: Simple scarfing jig for handplanes
ancient kayaker -- 5/5/2013, 10:40 am
Re: Strip: Simple scarfing jig for handplanes
Bill Hamm -- 5/6/2013, 12:45 am
Re: Strip: Simple scarfing jig for handplanes
Mike Savage -- 5/6/2013, 2:16 pm
Re: Strip: Simple scarfing jig for handplanes
ddaniels -- 5/7/2013, 5:01 pm
Re: Strip: Simple scarfing jig for handplanes
ddaniels -- 5/7/2013, 5:03 pm
Re: Strip: Simple scarfing jig for handplanes
Bill Hamm -- 5/8/2013, 12:46 am