: I can't find the image now, but a very clever builder out there put lengths
: of bicycle inner tube over the jaw end of his spring clamps. He'd then
: glue a strip in place and clamp it so that the rubber pressed against the
: inner (narrow) edge of the strip.
: The result is that the spring clamp jaws hold onto the previous strip,
: allowing the rubber band to press the current strip against the previous
: strip. It allows you to put as much pressure on the strip as needed,
: exactly where it's needed.
: I really hope this makes sense!
: -Greg H
: St. Paul MN
Is this similar to what you are talking about? With the first 5 or 6 strips I clamped by wrapping long rubber bands around the strips as in a previous picture but after the hull turned the corner the bands pulled down too much and not against the joint so I went to another method whereas I used fatter rubber bands across the jaws of the spring clamps and just pushed them over the new strips and clamped it to the last few strips. To get more holding power I would double up the bands as needed. It goes pretty quick as you just sling the band across the jaws of the clamp, hold it on the clamp with one hand as you open the jaws with the other, push it on and let it go.
Messages In This Thread
- Strip: Glue and tight joints *Pic*
mtkayak -- 2/23/2009, 2:36 pm- Re: Strip: Glue and tight joints
Greg H -- 2/24/2009, 9:14 am- Re: Strip: Glue and tight joints *Pic*
Scott Fitzgerrell -- 2/24/2009, 5:53 pm- Re: Strip: Glue and tight joints *Pic*
Scott Fitzgerrell -- 2/24/2009, 5:55 pm- Re: Strip: Glue and tight joints
wwfloyd -- 2/24/2009, 10:11 pm- Re: Strip: Glue and tight joints
Scott Fitzgerrell -- 2/24/2009, 10:54 pm
- Re: Strip: Glue and tight joints
- Re: Strip: Glue and tight joints
- Re: Strip: Glue and tight joints *Pic*
mtkayak -- 2/24/2009, 9:52 am- Re: Strip: Glue and tight joints
Greg H -- 2/24/2009, 11:14 am- Re: Strip: Glue and tight joints
mtkayak -- 2/24/2009, 11:51 am- Re: Strip: Glue and tight joints
Etienne Muller -- 2/24/2009, 5:21 pm
- Re: Strip: Glue and tight joints
- Re: Strip: Glue and tight joints
- Re: Strip: Glue and tight joints *Pic*
- Re: Strip: Glue and tight joints
Bill Hamm -- 2/24/2009, 8:55 am- Re: Strip: Glue and tight joints
Todd Sullivan -- 2/23/2009, 9:43 pm- Re: Strip: Glue and tight joints
Paul Wiley -- 2/23/2009, 5:01 pm- Re: Strip: Glue and tight joints *LINK* *Pic*
Etienne Muller -- 2/23/2009, 4:07 pm- Re: Strip: Glue and tight joints
mtkayak -- 2/23/2009, 5:00 pm- Re: Strip: Glue and tight joints
Etienne Muller -- 2/23/2009, 5:47 pm
- Re: Strip: Glue and tight joints
- Re: Strip: Glue and tight joints
Allan -- 2/23/2009, 3:41 pm- Re: Strip: Glue and tight joints
fred graus -- 2/23/2009, 3:14 pm - Re: Strip: Glue and tight joints *Pic*
- Re: Strip: Glue and tight joints