Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Yak Security
By:Chip Sandresky
Date: 3/7/2003, 5:00 pm
In Response To: Re: Yak Security (Dave Houser)

: If you install full height cheek plates, from deck to hull on each side of
: your seat, you can use a bicycle lock cable to loop around the cheek plate

... or if you put a deck plate in your rear bulkhead then you can run a cable lock through the bulkhead and out the rear hatch. Then the evil boat stealers would have to either cut through the lock or the deck.

Messages In This Thread

Other: "Extra" Outfitting - "D" Rings
Rick Sylvia -- 3/6/2003, 11:37 am
Re: Other: "Extra" Outfitting - "D" Rings
Rob Peterson -- 3/7/2003, 11:43 am
Re: Like these? *Pic*
Shawn Baker -- 3/7/2003, 3:06 pm
Re: Entrapment
Roger Nuffer -- 3/8/2003, 1:45 pm
Do as I say, not as I do....
Shawn Baker -- 3/10/2003, 10:45 am
Re: Well said. Now about that disclaimer...
Roger Nuffer -- 3/10/2003, 11:57 am
Re: Well said. Now about that disclaimer...
Paul G. Jacobson -- 3/10/2003, 10:50 pm
Re: Well said. Now about that disclaimer...
Shawn Baker -- 3/10/2003, 1:26 pm
yes
Rob Peterson -- 3/7/2003, 3:28 pm
Re: yes
Shawn Baker -- 3/7/2003, 4:21 pm
Re:Good Ideas!
Rick Sylvia -- 3/7/2003, 10:22 am
Re: Other: "Extra" Outfitting - "D" Rings
John Gray -- 3/6/2003, 8:39 pm
Re: Other: "Extra" Outfitting - "D" Rings
Paul G. Jacobson -- 3/6/2003, 5:58 pm
Re: Other: "Extra" Outfitting - "D" Rings
Brian Nystrom -- 3/6/2003, 1:56 pm
Re: Other: "Extra" Outfitting - "D" Rings
Rick Sylvia -- 3/6/2003, 2:12 pm
Re: Other: "Extra" Outfitting - "D" Rings
Brian Nystrom -- 3/6/2003, 3:16 pm
Grap loops too!
Greg Bridges -- 3/6/2003, 3:44 pm
Re: Yak Security
Dave Houser -- 3/7/2003, 4:08 pm
Re: Yak Security *LINK* *Pic*
Robert Woodard -- 3/11/2003, 10:19 am
Re: Yak Security *LINK* *Pic*
Andy Waddington -- 3/9/2003, 4:07 pm
Yak Security
greg root -- 3/7/2003, 10:08 pm
Re: Yak Security
Steve Frederick -- 3/7/2003, 6:12 pm
Re: Yak Security
Chip Sandresky -- 3/7/2003, 5:00 pm
Re: I second that *NM*
Ryan -- 3/6/2003, 11:49 am