Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

No Holes Hatch leash
By:Mike
Date: 6/19/2001, 12:18 am
In Response To: Hatch leash (EdG)

No holes please!!

Easy solution to this: Get two plastic padeyes for each hatch. Make up some epoxy thickened to a putty consistancy. Put a blob of this stuff on your hatch cover. (Close to the middle is best to stay out of the way of the gasket) and sink a padeye in it so the putty oozes up through the padeye holes. Let it harden. do the same at a point inside the boat. put a length of cord through both padeyes with a knot to hold both ends in place. You are all set.

Mike

-------------------------
Just thought I'd ask for some opinions/suggestions - I'd like to add a
: "leash" to the hatch covers on my Coho, so that I don't have to
: worry about misplacing them, or having them slip into the water and float
: away as I'm unpacking my kayak.

: This could be an obvious answer; just drill a hole through the hull and the
: hatch, add some type of screw, and then connect with bungee - bingo, I'm
: done. But before I start messing up that pretty deck, I thought I'd see if
: anyone else had other ideas.

: FYI, the Coho uses a lip on which the hatch sits, so that the hatch is flush
: mounted.

: Any suggestions are appreciated!

: TIA
: Ed

Messages In This Thread

Hatch leash
EdG -- 6/18/2001, 10:49 am
Re: Where's Edgar?
Ross Leidy -- 6/19/2001, 9:10 am
No Holes Hatch leash
Mike -- 6/19/2001, 12:18 am
Re: Hatch leash
Doug -- 6/18/2001, 8:34 pm
Re: Hatch leash
Don Beale -- 6/18/2001, 12:25 pm
Re: Hatch leash
Greg Steeves -- 6/18/2001, 11:06 am
Re: Hatch leash
Dave Webber -- 6/18/2001, 5:51 pm
Re: Hatch leash
Larry C. -- 6/18/2001, 11:38 am