Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
: I'm searching for a source for 3/8" radius cove-and-bead router bits,
: either 1/4" or 1/2" dia. shaft. Any recommendations?
For the flute, or cove, look at the link at the bottom. If I read the specs right, this should have a 3/8th inch radius on the cutter. The bit comes with bearings that are probably of no use to you, but you'll pay for them anyhow -- or you could ask about ordering the bit without them, and see if you can save some $$$.
Grizzly also has several beading bits and roundover bits in 3/8th inch radius cut.
For the bead cutter try this link:
http://grizzly.com/fcgi-bin/lookup.fcgi/products/lookup.cfg?q=item&kw=C1023
hope this helps
PGJ
Messages In This Thread
- 3/8 radius router bits
Pete -- 4/10/2001, 4:35 am- Sure you don't want to rethink this whole thing?
Paul G. Jacobson -- 4/12/2001, 10:44 pm- Rethought
Pete -- 4/14/2001, 9:21 am- Re: Rethought
Paul G. Jacobson -- 4/15/2001, 7:05 pm- Re: Rethought
Pete -- 4/16/2001, 7:13 am
- Re: Rethought
- Re: Hey another option!
Geo. Cushing -- 4/13/2001, 3:03 pm- Enough Already
Pete -- 4/14/2001, 8:39 am- Re: Enough Already
Geo. Cushing -- 4/17/2001, 3:13 pm
- Re: Hey another option!
Ben Staley -- 4/13/2001, 3:08 pm - Re: Enough Already
- Re: Rethought
- Try Grizzly *Pic*
Paul G. Jacobson -- 4/11/2001, 12:40 am- Re: 3/8 radius router bits
Geo. Cushing -- 4/10/2001, 10:59 am- Re: 3/8 radius router bits
Pete -- 4/10/2001, 1:46 pm- more on radiuses *Pic*
Paul G. Jacobson -- 4/11/2001, 12:17 am- Re: more on radiuses
daren neufeld -- 4/11/2001, 12:24 am
- radius question
Paul G. Jacobson -- 4/11/2001, 12:04 am- Re: 3/8 radius router bits
daren neufeld -- 4/10/2001, 10:59 pm- Radius vs Diameter
Pete -- 4/11/2001, 7:09 am- Re: Radius vs Diameter
daren neufeld -- 4/11/2001, 8:54 am
- Re: Radius vs Diameter
- Re: 3/8 radius router bits
Rehd -- 4/10/2001, 1:53 pm - Re: more on radiuses
- Re: More Info
Geo. Cushing -- 4/10/2001, 12:59 pm - more on radiuses *Pic*
- Re: 3/8 radius router bits
John Monfoe -- 4/10/2001, 5:19 am - Rethought
- Sure you don't want to rethink this whole thing?
