Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Sanding... thought I was done
By:Doyle
Date: 1/10/2001, 12:37 pm
In Response To: Re: Sanding... thought I was done (Bill Price)

: Could you use some thin slivers of similar wood to fill your gaps? These
: would be less noticable than epoxy. You may not even have to glue them in
: as they will be saturated with epoxy and covered with glass later.

: Bill

I used thin slivers for the small gaps, I am talking about the really small gaps. It is possible I am being a little annal about the whole thing.

I built a Coho last year and had fun, but building a strip boat has been even more satisfying. I will be much more carefull with the glue when I start on the deck.

Messages In This Thread

Sanding... thought I was done
Doyle -- 1/9/2001, 9:52 pm
Re: Sanding... thought I was done
Earl Bailey -- 1/10/2001, 2:38 pm
Re: Sanding... thought I was done
Larry C. -- 1/10/2001, 3:29 pm
Re: Sanding... thought I was done
Mitch Isoe -- 1/11/2001, 11:38 am
Re: Sanding... thought I was done
Dan -- 1/10/2001, 12:41 pm
Re: Sanding... thought I was done
Bill Price -- 1/10/2001, 11:54 am
Wood Flour
John Monfoe -- 1/11/2001, 4:14 am
Re: Sanding... thought I was done
Doyle -- 1/10/2001, 12:37 pm
Re: Sanding... thought I was done
Ken Finger -- 1/10/2001, 7:45 am
Alternate View
Lars Durban -- 1/10/2001, 3:46 pm
Re: Alternate View
Ken Finger -- 1/11/2001, 8:02 am
Re: Sanding... thought I was done
John Monfoe -- 1/10/2001, 4:47 am
Re: Basically, You Are
Rehd -- 1/9/2001, 11:50 pm
Re: They have a word for that
Jim P. -- 1/10/2001, 9:00 am
Re: "Perfection Offends the Gods" *NM*
George Cushing -- 1/12/2001, 2:19 pm
Re: I agree!! *NM*
Rehd -- 1/11/2001, 12:04 pm