Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Thx Reg, BillH, JohnC & DW's
By:Bill Hamm
Date: 11/29/2010, 1:48 am
In Response To: Thx Reg, BillH, JohnC & DW's (Kurt Maurer)

: I've hesitated to use them because I already know I make short work
: of Keepers. I romp and stomp on my foot braces, and don't want
: surprises either. If Reg, Bill H, and John C endorse 'em, I'll
: give 'em a try on my next yak. Chuck and Sandra, the peeps
: behind DWs, are personal friends and I'd sure prefer to buy from
: them.

: DWs also sells rubber hatches and rings ala VCP/KajakSport that
: cost a heck of a lot less, look just as good. They sent me one
: to inspect when I was building my OI v.2, but I ultimately went
: with flush hatches to save lbs, $$$ and looks.

This is why I use Yakimas, they never break, even in the rental fleet. Also you can actually adjust them (with your feet) from a tiny ocean cockpit. I'll admit it does take some time to learn how to do this, normally don't use the tops of the feet for much of anything :)

Bill H.

Messages In This Thread

Material: Duckworks foot braces *PIC*
Tim Abbott -- 11/28/2010, 2:06 am
Re: Material: Duckworks foot braces
Rod Tait (Orca Boats) -- 11/28/2010, 11:14 am
it's all I use
Kudzu -- 11/28/2010, 10:43 am
Re: Material: Duckworks foot braces
wwfloyd -- 11/28/2010, 8:22 am
Re: Material: Duckworks foot braces
Scott Baxter -- 11/28/2010, 7:15 am
Re: Material: Duckworks foot braces
Paul Montgomery -- 11/28/2010, 7:10 am
Re: Material: Duckworks foot braces
Bill Hamm -- 11/28/2010, 3:56 am
Re: Material: Duckworks foot braces
Reg Lake -- 11/28/2010, 11:57 am
Re: Material: Duckworks foot braces
Bill Hamm -- 11/28/2010, 12:10 pm
Re: Material: Duckworks foot braces
Bill Hamm -- 11/28/2010, 12:11 pm
Re: Material: Duckworks foot braces
Reg Lake -- 11/28/2010, 12:43 pm
Thx Reg, BillH, JohnC & DW's
Kurt Maurer -- 11/28/2010, 6:57 pm
Re: Thx Reg, BillH, JohnC & DW's
Bill Hamm -- 11/29/2010, 1:48 am
I like them
John Caldeira -- 11/28/2010, 3:14 am