Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Need advice on a work table for my S&G pr
By:Bob Kelim
Date: 4/25/2003, 10:27 am
In Response To: S&G: Need advice on a work table for my S&G project. (Ken)

I use a 2' wide table with 2X4 framing, works for me. The one thing I've not seen in the above posts is to leave a lip on the table so you can use clamps to hold your panels and battens down during the lay out and cutting process. Use OSB or whatever is cheapest and cut your panels with a circular saw right on the table. for me this is easier to control than a saber saw and it leaves a smoother edge.
Bob

Messages In This Thread

S&G: Need advice on a work table for my S&G project.
Ken -- 4/24/2003, 1:25 pm
Re: S&G: Need advice on a work table for my S&G pr
Tony W. -- 4/26/2003, 5:24 pm
Re: S&G: Need advice on a work table for my S&G pr *LINK* *Pic*
Steve Frederick -- 4/25/2003, 5:26 pm
Re: S&G: Need advice on a work table for my S&G pr
Bob Kelim -- 4/25/2003, 10:27 am
Advice on a work table for my S&G project.
Paul G. Jacobson -- 4/24/2003, 10:35 pm
Thanks for the detailed info.
Ken -- 4/25/2003, 12:33 pm
Re: Bench and Cradles
Rehd -- 4/24/2003, 8:55 pm
Wow! You guys sure are helpful.
Ken -- 4/24/2003, 9:25 pm
Re: Wow! You guys sure are helpful.
Rehd -- 4/24/2003, 10:37 pm
Re: S&G: Need advice on a work table for my S&G pr
Jeff J -- 4/24/2003, 6:04 pm
Re: S&G: Need advice on a work table for my S&G pr
RickR -- 4/24/2003, 5:33 pm
Re: S&G: Need advice on a work table for my S&G pr
Dan G -- 4/24/2003, 5:04 pm
Re: S&G: Need advice on a work table for my S&G pr *LINK*
Mark Normand -- 4/24/2003, 4:50 pm
Re: S&G: Need advice on a work table for my S&G pr
srchr/gerald -- 4/24/2003, 4:32 pm
Re: 16ft Table
Chip Sandresky -- 4/24/2003, 4:19 pm
Re: S&G: flex space
mike allen -- 4/24/2003, 2:33 pm
Re: S&G: Need advice on a work table for my S&G pr
Dennis -- 4/24/2003, 2:16 pm
Re: S&G: Need advice on a work table for my S&G pr
Ryan -- 4/24/2003, 1:46 pm
Re: S&G: Need advice on a work table for my S&G pr
Ryan -- 4/24/2003, 1:51 pm