Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: table saw blades
By:ken
Date: 10/29/2001, 5:16 pm
In Response To: table saw blades (mike arnopol)

The 8" Freud thin kerf teflon coated rip blade works just fine for me.

Ken

Messages In This Thread

table saw blades
mike arnopol -- 10/29/2001, 4:54 pm
go 7 1/2"
Jay Babina -- 10/30/2001, 11:06 am
Re: table saw blades
Nick Schade - Guillemot Kayaks -- 10/30/2001, 8:54 am
three blades
David Barrett -- 10/30/2001, 2:57 pm
Re: table saw blades
Jim Kozel -- 10/30/2001, 9:50 am
Re: Blade Spacers
Nick Schade - Guillemot Kayaks -- 10/30/2001, 11:48 am
A new tool idea for any enterprising tool maker
Paul G. Jacobson -- 10/30/2001, 9:04 pm
Re: table saw blades
daren neufeld -- 10/29/2001, 8:59 pm
Re: clamps
bob Kelim -- 10/29/2001, 8:53 pm
Re: clamps
Matthew -- 10/29/2001, 9:21 pm
Re: clamps *NM*
Alice -- 10/29/2001, 9:02 pm
Re: table saw blades
ken -- 10/29/2001, 5:16 pm
Re: table saw blades
jim kozel -- 10/29/2001, 10:31 pm
Re: table saw blades
mike arnopol -- 10/29/2001, 4:56 pm