Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Thin strip jig. Off topic
By:Mike Savage
Date: 1/6/2008, 2:13 pm
In Response To: Re: Strip: Thin strip jig. Off topic (John Michne)

: Mike ?

: You are correct ? the apparent question marks you see are indeed one quarter
: inch. I used Word to compose the post, and when I type the numerals
: one-slash-four the program automatically converts them to a single small
: special symbol of one over four. It came through OK both when I previewed
: the post and later on the forum. I use Internet Explorer 7 as my browser,
: which handles it OK. Lesson learned ? next time, I will be sure to not
: post fractions that way.

: - John

Hi John,
That could explain it. I'm using IE6. I use the forum Post Response, I know the format will stay the same.
I think that a few posters use Word for their posts, the format change does effect 'special' symobols.
I do use Word for writing emails but I disabled the autoformat thingie. I'm not keen on having a machine second-guess me. :)

Mike Savage
South West Cork

Messages In This Thread

Strip: Thin strip jig
Greg Clopton -- 1/4/2008, 7:04 pm
Re: Strip: Thin strip jig *LINK*
John Michne -- 1/5/2008, 8:06 am
Re: Strip: Thin strip jig
Dale F. Jeffers -- 1/6/2008, 1:08 pm
Re: Strip: Thin strip jig
John Michne -- 1/6/2008, 1:35 pm
Re: Strip: Thin strip jig
Dale F. Jeffers -- 1/6/2008, 1:40 pm
bad links
Paul G. Jacobson -- 1/6/2008, 5:19 pm
Re: bad links
Dale F. Jeffers -- 1/6/2008, 5:31 pm
Re: Strip: Thin strip jig *LINK*
Ted Henry -- 1/6/2008, 2:52 pm
Re: Strip: Thin strip jig
Dale F. Jeffers -- 1/6/2008, 2:57 pm
Re: Strip: Thin strip jig
Glen Smith -- 1/6/2008, 1:43 pm
Re: Strip: Thin strip jig
Paul G. Jacobson -- 1/5/2008, 5:43 pm
Re: Strip: Thin strip jig
John Michne -- 1/6/2008, 6:52 am
Re: Strip: Thin strip jig. Off topic
Mike Savage -- 1/6/2008, 10:18 am
Re: Strip: Thin strip jig. Off topic
John Michne -- 1/6/2008, 10:54 am
Re: Strip: Thin strip jig. Off topic
Mike Savage -- 1/6/2008, 2:13 pm
Re: Strip: Thin strip jig
Mike Scarborough -- 1/5/2008, 9:13 am
Re: Strip: Thin strip jig
Paul G. Jacobson -- 1/5/2008, 5:57 pm
Oh, yeah! The link:
Greg Clopton -- 1/4/2008, 7:05 pm
Re: Oh, yeah! The link:
Kudzu -- 1/4/2008, 9:14 pm
Re: Oh, yeah! The link:
Bob Zani -- 1/5/2008, 6:38 am