Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Router Jigs for Milling Strips
By:Rick Hewitt
Date: 9/27/1998, 10:35 am

Good morning to all from the Sunny West Coast. I have read somewhere in my research that If you use two routers in a specially made Jig that you can mill both sides of the strips in one pass. Is there more information and possibly even plans for such a Jig - table - that will mount the routers as appropriate ??

Thanks for any help - pointers or past experience stories.


Messages In This Thread

Router Jigs for Milling Strips
Rick Hewitt -- 9/27/1998, 10:35 am
Re: Router Jigs for Milling Strips
Mark Kanzler -- 9/27/1998, 11:06 am