Date: 4/4/2001, 5:27 am
: Spidey,
: What type of heat gun gun would you reccommend? Any particular wattage
: needed?
: I've seen one in the local hardware store and it was around $39.00 but I
: forgot the heat output.
: Thanks,
: Steve
Hi Steve,
When I bought my Wagner heat gun, made in China, I had a choice of two different kinds in the True Value hardware store. One was around $40 and the Wagner # HT1000, was about $25 as I remember. It has two heat settings but the only one listed on the gun is 1200 watts. That sound like a hair dryer but it gets very hot and will scorch your wood if you aren't careful and easily burns the wood fuzz off. It worked for me but I also use an iron, steaming, soaking, but at the end of my stripping I was slitting the strips down the middle with a utility knife where the hard bend was at. Slitting turned out to be the one that worked best for me and was the quickest. Before I glued the strip on I spread the slit and forced glue in it and then glued the strip onto the boat.
John
Messages In This Thread
- Steam bending
Kent LeBoutillier -- 3/29/2001, 12:03 pm- Re: Steam bending
Arthur -- 3/30/2001, 3:59 am- Re: Steam bending *Pic*
Rehd -- 3/30/2001, 1:46 am- Re: CPVC and Hot Air
Spidey -- 3/29/2001, 10:57 pm- Re: CPVC and Hot Air
Dean G. -- 3/31/2001, 10:06 am- Re: Steaming and Hot air guns
Shawn Baker -- 3/30/2001, 3:52 pm- Re: Steaming and Hot air guns
Spidey -- 3/30/2001, 6:53 pm- What type of heat gun?
Steve -- 4/3/2001, 10:31 am- Re: What type of heat gun?
John Monfoe -- 4/4/2001, 5:27 am
- Re: What type of heat gun?
- What type of heat gun?
- Re: Steaming and Hot air guns
- Re: Steam bending
marc leclerc -- 3/29/2001, 10:57 pm- Re: Steam bending
Dick Gamble -- 3/29/2001, 2:19 pm- Re: Steam bending
Dean G. -- 3/29/2001, 4:10 pm
- Re: Steam bending
Steve Lein -- 3/29/2001, 1:51 pm- Getting bent *Pic*
Bill Price -- 3/29/2001, 3:37 pm- Re: Steam bending
Rob Macks -- 3/29/2001, 3:07 pm- Re: Steam bending
Kent LeBoutillier -- 3/29/2001, 2:01 pm - Re: Steam bending
- Re: Steam bending
Elliott -- 3/29/2001, 1:41 pm - Re: Steam bending *Pic*
- Re: Steam bending