Thanks for all of the advice. I marked a guide line on the panels for the edge of the sheer clamps. Drilled three small holes through both panels, one at each end, one in the middle, and then inserted a 3d finishing nail through each hole to act as a stop (thanks Lee). Pre-coated all of the surfaces with unthickened epoxy, then mixed up some thickened goop. Got my wife and my daughter to help hold the pieces while I clamped, working out from the middle to each end. (Man, that takes a LOT of clamps!) And yes, I put some packaging tape on the panels. Now I'll just have to wait and see what it looks like tomorrow. Once again, THANKS! Dennis