Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Putting a 5 deg. bevel on strips
By:ancient kayaker
Date: 12/11/2010, 2:36 pm
In Response To: Re: Strip: Putting a 5 deg. bevel on strips (Bill Hamm)

: I suppose with a router table and lots of finger boards this might
: be possible. The strips arn't real solid platforms to work on
: with a router.
...
: Bill H.

- perhaps I should clarify: the router is used on the edge of the plank B4 the strip is cut off. It's plenty solid enough for routing. Routing the strips after they were cut off didn't work well, even with my table router.

Messages In This Thread

Strip: Putting a 5 deg. bevel on strips
Stephen Troy -- 12/10/2010, 2:27 am
Re: Strip: Putting a 5 deg. bevel on strips
Rob Macks / Laughing Loon CC&K -- 12/10/2010, 8:45 am
Thanks Rob! *NM*
Stephen Troy -- 12/10/2010, 11:22 am
Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/10/2010, 9:22 am
Re: Strip: Putting a 5 deg. bevel on strips
ancient kayaker -- 12/10/2010, 10:50 am
Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/11/2010, 12:19 am
Re: Strip: Putting a 5 deg. bevel on strips
ancient kayaker -- 12/11/2010, 2:36 pm
Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/12/2010, 12:46 am
Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/12/2010, 12:47 am
Re: Strip: Putting a 5 deg. bevel on strips
Randy Echtinaw -- 12/10/2010, 5:03 am
Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/10/2010, 8:19 am
Re: Strip: Putting a 5 deg. bevel on strips
Randy Echtinaw -- 12/10/2010, 9:40 am
Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/10/2010, 2:43 pm
Re: Strip: Putting a 5 deg. bevel on strips
Jay Babina -- 12/10/2010, 10:42 am
Re: Strip: Putting a 5 deg. bevel on strips
Randy Echtinaw -- 12/10/2010, 11:01 am