Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Hatches: weight of hatch flange
By:Ian Johnson
Date: 11/12/2010, 1:14 am
In Response To: Re: Strip: Hatches: weight of hatch flange (Bill Hamm)

: I've never weighed mine. They do though have to be fairly strong,
: unless you're using magnets to hold them down, they have to
: constantly resist whatever method is holding the hatches on, if
: not pretty strong they'll deflect over time and will leak.

: Bill H.

Thanks. How much overlap do you leave with the deck? (I mean as a gluing surface.) The notes say 1 1/2" or thereabouts, which does seem like a lot of gluing surface, I was wondering if more like 1/2 - 3/4" would be sufficient.

Cheers, Ian

Messages In This Thread

Strip: Hatches: protecting gasket while glassing lip
Ian Johnson -- 11/8/2010, 5:33 pm
Re: Strip: Hatches: weight of hatch flange
Ian Johnson -- 11/11/2010, 7:01 pm
Re: Strip: Hatches: weight of hatch flange
Bill Hamm -- 11/12/2010, 12:46 am
Re: Strip: Hatches: weight of hatch flange
Ian Johnson -- 11/12/2010, 1:14 am
Re: Strip: Hatches: weight of hatch flange
Bill Hamm -- 11/12/2010, 9:08 am
Re: Strip: Hatches: weight of hatch flange
Bill Hamm -- 11/12/2010, 6:16 am
Re: Strip: Hatches: weight of hatch flange
Ian Johnson -- 11/12/2010, 8:40 pm
Re: Strip: Hatches: protecting gasket while glassi *PIC*
Kurt Maurer -- 11/8/2010, 6:59 pm
Re: Strip: Hatches: protecting gasket while glassi
Tony -- 11/11/2010, 5:57 pm
Re: BTW that's a beautiful deck
Ian Johnson -- 11/8/2010, 7:43 pm
Re: Strip: Hatches: protecting gasket - answered!
Ian Johnson -- 11/8/2010, 7:41 pm
Re: Strip: Hatches: protecting gasket - answered! *PIC*
Kyle T -- 11/9/2010, 9:49 am
Re: Strip: Hatches: protecting gasket - answered!
Ian Johnson -- 11/11/2010, 7:04 pm
Re: Strip: Hatches: protecting gasket - answered!
Bill Hamm -- 11/8/2010, 8:24 pm
Re: Strip: Hatches: protecting gasket - answered!
dave g -- 11/8/2010, 8:05 pm
Re: Strip: Hatches: protecting gasket - answered!
Ian Johnson -- 11/9/2010, 1:35 am