Date: 2/3/2009, 8:22 pm
: Hello,
: this is my first post towards building my first kayak. i recently got my
: plans for a Night Heron. i've gone out and purchased a router and router
: table combo from Canadian Tire. i then returned it because when i mounted
: the router under the table and raised the router all the way up the bit
: didn't clear the table.
: i went to Home Depot and purchased a Ryobi router and table and i'm having
: the same issue. i've raised the bit in the collet a 1/16 of an inch like
: the instructions suggested (to allow for expansion due to heat). but the
: bit needs to come up another 1/8 to 1/4 of an inch to be at the proper
: height.
: originally i didn't feel that i should have to do this because i assumed that
: the router should be able to adjust to this height. but after buying a
: second router that has the same issue i'm starting to wonder. do you have
: any input? should i just raise the bit the little i need to have it work?
: will this effect the bit? or the quality of the bead and cove?
: any help would be greatly appreciated!
: thank,
: Adrian
Adrian, did you take the router base off before you mounted the router to to the table. I would not raise the bit any higher in the collet. Peter
Messages In This Thread
- Tools: Router, Table and Bits Question
Adrian -- 2/3/2009, 8:09 pm- Re: Tools: Router, Table and Bits Question *LINK*
James Kingston -- 2/5/2009, 3:01 pm- Re: Tools: Router, Table and Bits Question
Adrian -- 2/5/2009, 6:35 pm
- Re: Tools: Router, Table and Bits Question *LINK* *Pic*
Pawistik -- 2/4/2009, 12:10 pm- Re: Tools: Router, Table and Bits Question
Jay Babina -- 2/4/2009, 8:09 am- Re: Tools: Router, Table and Bits Question
Kudzu -- 2/3/2009, 10:05 pm- Re: Tools: Router, Table and Bits Question
Peter Woodward -- 2/3/2009, 8:22 pm- Re: Tools: Router, Table and Bits Question
Adrian -- 2/3/2009, 8:27 pm
- Re: Tools: Router, Table and Bits Question
- Re: Tools: Router, Table and Bits Question *LINK*