Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: Brush or Roll on oil based spar
By:Bill Hamm
Date: 4/21/2008, 2:07 am

: That depends on where you paddle. While fresh water will definitely cause
: rot, salt water is actually a very good wood preservative. That's one
: reason you should not rinse out a boat with fresh water after paddling on
: the ocean.

: True, but you must use tung oil (the pure stuff), NOT linseed oil, as mold
: and mildew feed on linseed oil. Varnishing the frame is a bad idea, since
: the finish will eventually crack, water will get under it and become
: trapped, and rot will form.

That's true, since I live in the midwest I'd forgotten about salt water, does tend to act as a preservative, though the crystals formed are abrasive against the skin so there's a downside too.

Linseed oil is a poor choice for most woodwork with the possible exception of furniture, even then tung oil is better IMHO.

I coated my frame with epoxy, it won't tend to crack and only adds maybe a pound to the boat, it's protected from the sun by the skin too.

Bill H.

Messages In This Thread

Skin-on-Frame: Brush or Roll on oil based spar urethane?
Brent -- 4/17/2008, 4:34 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 4/20/2008, 9:39 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 4/21/2008, 2:10 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Phil Nelson -- 2/5/2009, 6:22 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 2/5/2009, 2:24 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 2/6/2009, 9:51 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 2/6/2009, 9:56 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 2/5/2009, 7:44 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Phil Nelson -- 2/5/2009, 10:40 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 2/6/2009, 9:45 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 2/6/2009, 9:54 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Glen Smith -- 2/6/2009, 12:00 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Scott Shurlow -- 4/18/2008, 6:26 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 4/20/2008, 1:06 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 4/20/2008, 9:35 am
Darin Wright
Blanche Barnes -- 11/13/2008, 2:14 am
*SPAM* *NM*
Greg H -- 11/14/2008, 12:46 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 4/21/2008, 2:07 am