Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: yost seats
By:Scott Shurlow
Date: 12/23/2007, 6:35 pm
In Response To: Re: Skin-on-Frame: yost seats (Paul G. Jacobson)

: If you have wooden frames you can lay slats of 3/8"x2 stock over them.
: Just use small screws in predrilled holes to hold them in place. Leave a
: gap of about 1/4 inch between the slats so they drain if things get wet

You don't find that that raises the center of gravity too high?
Scott

Messages In This Thread

Skin-on-Frame: yost seats
Scott Shurlow -- 12/23/2007, 8:06 am
Re: Skin-on-Frame: yost seats
Bill Hamm -- 12/24/2007, 1:22 am
Re: Skin-on-Frame: yost seats
Scott Shurlow -- 12/24/2007, 6:24 am
Re: Skin-on-Frame: yost seats
Bill Hamm -- 12/25/2007, 1:16 am
Re: Skin-on-Frame: yost seats
David, Tasmania -- 12/24/2007, 12:00 am
Re: Skin-on-Frame: yost seats
Bill Hamm -- 12/24/2007, 1:25 am
Re: Skin-on-Frame: yost seats
Paul G. Jacobson -- 12/23/2007, 5:42 pm
Re: Skin-on-Frame: yost seats
Scott Shurlow -- 12/23/2007, 6:35 pm
Re: Skin-on-Frame: yost seats
Bill Hamm -- 12/24/2007, 1:23 am