Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Paddle engineering
By:Nick Schade
Date: 8/24/1998, 3:14 pm
In Response To: Paddle engineering (Timothy - Toronto, Ontario)

I think the typical greenland paddle has the shoulder, but they work fine without it. I would not be too worried about stress risers.

> Does a greenland paddle need a "shoulder" where the
> shaft meets the blade, or not? My knowledge of engineering is just
> about zero, but it seems there would be a concentration of stress
> where the two meet. Would a shoulder help by strengthening this point,
> or would a smooth transition from the shaft to the blade do a better
> job?

> Below is a link to an article that provides a detailed drawing
> of a how a shoulder is made (see Step 4 in the diagram). An equally
> convincing article says there is no need for a shoulder. Any thoughts?

Messages In This Thread

Paddle engineering
Timothy - Toronto, Ontario -- 8/24/1998, 9:03 am
Re: Paddle ergonomics
Rick Rubio -- 8/25/1998, 5:16 pm
Drip Ring
Jon -- 8/24/1998, 9:44 pm
Re: Paddle engineering
Nick Schade -- 8/24/1998, 3:14 pm
Re: Paddle engineering
Mark Kanzler -- 8/24/1998, 11:48 am