Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Radius Panel Corners
By:Dave Houser
Date: 5/6/2001, 5:43 pm
In Response To: Re: Radius Panel Corners (Mike Scarborough)

: Dave, is it fair to say that this technique works well in our universe of 1/8
: inch, 1/4 inch, 3mm, 4mm plywood? I seem to recall construction details on
: Sam Devlin's boats showing beveled panel edges. Of course, he's working in
: a world of 1/2+ inch panel thicknesses.

: Mike

Good point. CLC on their web page in their "Shop Tips" also recommends to "round your edges". But that again is for 4mm plywood.

Messages In This Thread

stitch and glue tender
patrick -- 5/5/2001, 6:53 pm
making mitres
mike allen ---> -- 5/9/2001, 2:43 pm
Re:Old cabinet builder trick.
Tony -- 5/9/2001, 2:26 pm
Re: Radius Panel Corners
Dave Houser -- 5/5/2001, 7:08 pm
Re: Radius Panel Corners
Mike Scarborough -- 5/6/2001, 9:28 am
Re: Radius Panel Corners
Dave Houser -- 5/6/2001, 5:43 pm
Re: Radius Panel Corners
patrick -- 5/6/2001, 4:42 am