Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Foam Brushes
By:Nick Schade - Guillemot Kayaks
Date: 3/26/2001, 10:21 am
In Response To: Re: Foam Brushes (Richard Boyle)

I would not use either the US or China manufactured brushes for epoxy. I would not trust either to hold up very long. I use "chip" brushes for the epoxy, while the non US version tend to lose bristles easily they are still better than foam for the purpose.

: I found the opposite. While tipping out the epoxy yesterday on my Guillemot's
: deck, the Jen Polybrush started to disintegrate leaving lots of little
: bits of foam in my finish. Up to that coat I had been using "made in
: china" Simms brushes without any problems, but had run out, and
: bought some of the "made in usa" Jen brushes. I went back to
: the"made in china" brushes and haven't had any problems since. I
: suspect the Jen brushes might be old and rotting, they came from a
: different store.

Messages In This Thread

Varnishing problem
John Michne -- 3/22/2001, 7:04 pm
Re: Varnishing problem
Ronnie -- 3/23/2001, 1:25 pm
Re: Varnishing problem
Byron -- 3/23/2001, 9:37 am
Re: Varnishing problem
Ross Leidy -- 3/23/2001, 10:29 am
Electro-static dusting cloths
John Michne -- 3/23/2001, 10:49 am
Re: Electro-static dusting cloths
Larry C. -- 3/23/2001, 12:29 pm
Yes, very likely that's why *NM*
Ross Leidy -- 3/23/2001, 11:08 am
Re: Varnishing problem
Matthew -- 3/22/2001, 7:58 pm
Re: Varnishing problem
Rob Macks -- 3/22/2001, 7:19 pm
Re: Varnishing problem
John Michne -- 3/22/2001, 8:46 pm
Foam Brushes
Steve -- 3/23/2001, 10:56 am
Re: Foam Brushes
Richard Boyle -- 3/23/2001, 11:38 am
Re: Foam Brushes
Nick Schade - Guillemot Kayaks -- 3/26/2001, 10:21 am
Re: Foam Brushes
Richard Boyle -- 3/26/2001, 6:53 pm
Re: Foam Brushes *Pic*
Nick Schade - Guillemot Kayaks -- 3/27/2001, 9:14 am
Re: Foam Brush tip
Dean Trexel -- 3/27/2001, 10:06 am
Re: Foam Brush tip
Al Gunther -- 3/29/2001, 10:54 am
Re: Foam Brushes
Dave Houser -- 3/23/2001, 7:06 pm
Re: Varnishing problem
Nick Schade - Guillemot Kayaks -- 3/23/2001, 9:23 am
Re: Varnishing problem
Rob Macks -- 3/22/2001, 9:18 pm
Rob, Let Me Get This Straight....
Brion -- 3/23/2001, 12:05 pm
Re: Rob, Let Me Get This Straight....
Rob Macks -- 3/23/2001, 1:30 pm
varnishing
Mark S. -- 3/23/2001, 1:29 pm