Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Thin Kerf Blades
By:Steve
Date: 10/12/2000, 11:45 am

I was wondering if anyone can tell if the Freud thin kerf(0.78 kerf) 60 tooth 7deg. hook for a 10" table saw would be a good blade for cedar strips. They also make an 80 tooth with a .098 kerf 15 deg.hook. These are listed for mitering use in woodworkers warehouse catolog.
Thanks,
Steve

Messages In This Thread

Thin Kerf Blades
Steve -- 10/12/2000, 11:45 am
Re: Thin Kerf Blades
John Michne -- 10/12/2000, 12:37 pm
Re: Thin Kerf Blades
Steve -- 10/12/2000, 7:50 pm
Re: Thin Kerf Blades
John Michne -- 10/12/2000, 8:57 pm
Re: Thin Kerf Blades
bob -- 10/12/2000, 10:48 pm
Re: Thin Kerf Blades *Pic*
John Michne -- 10/13/2000, 7:26 am
Re: Thin Kerf Blades
Steve L -- 10/12/2000, 9:46 pm