Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: recessed fittings
By:Ross Leidy
Date: 2/14/2000, 4:34 pm
In Response To: Re: recessed fittings (Tom Preska)

Wrap the tip with duct tape so that half the tape is off the end. You can feed the duct tape leader through the hole and then stretch the bungie as you pull it through with the leader.

> Upon deep thought, How do you strech a bungie and force it through a
> smaller diameter hole? Anyone?

Messages In This Thread

Artic Tern - Recessed Deck Fittings
Paul Willliams -- 2/13/2000, 4:03 pm
Re: Artic Tern - Recessed Deck Fittings
erez -- 2/13/2000, 10:21 pm
recessed fittings
Tom Preska -- 2/14/2000, 11:17 am
Re: recessed fittings
Shawn Baker -- 2/14/2000, 2:03 pm
Re: recessed fittings
Larry C. -- 2/14/2000, 2:44 pm
Re: recessed fittings
Doug -- 2/14/2000, 8:03 pm
Re: recessed fittings
Tom Preska -- 2/14/2000, 4:23 pm
Re: recessed fittings
Matt Broze -- 2/23/2000, 3:18 am
Re: Ahhh Ha!
lee -- 2/23/2000, 6:55 am
Re: recessed fittings
Shawn Baker -- 2/14/2000, 5:43 pm
Re: OR
Joe Greenley -- 2/14/2000, 4:39 pm
Re: OR
Larry C. -- 2/14/2000, 5:14 pm
Re: recessed fittings
Ross Leidy -- 2/14/2000, 4:34 pm
Re: recessed fittings
Tom Preska -- 2/14/2000, 4:37 pm
Re: recessed fittings
Joe Greenley -- 2/14/2000, 4:34 pm
Re: recessed fittings
Kent LeBoutillier -- 2/14/2000, 11:36 am
Re: Recessed Deck Fittings - Pic#1
Dean Trexel -- 2/13/2000, 4:18 pm
Re: Recessed Deck Fittings - Pic#1
Paul Willliams -- 2/13/2000, 7:06 pm
Re: Recessed Deck Fittings - Pic#1
Dean Trexel -- 2/14/2000, 6:21 pm
Re: Recessed Deck Fittings - Pic#1
Mike Hanks -- 2/15/2000, 9:54 am
Re: Recessed Deck Fittings - Pic#1
Greg Hicks -- 2/16/2000, 8:04 am
Re: Rails
Mike Hanks -- 2/16/2000, 10:31 am
Re: Recessed Deck Fittings - Pic#1
lee -- 2/13/2000, 4:40 pm
Re: Recessed Deck Fittings - Pic#1
Dean Trexel -- 2/13/2000, 4:19 pm
Re: Recessed Deck Fittings - Pic#1
Kent LeBoutillier -- 2/14/2000, 9:29 am
Re: Recessed Deck Fittings - Pic#1
Dean Trexel -- 2/14/2000, 12:06 pm