Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Basically
By:Brian T. Cunningham
Date: 2/3/1999, 3:01 pm
In Response To: Re: Hole's in Hull (for handles) (Nolan Penney)


> Is it a concern over cutting the rope?

Yes. I was just going to bellmouth the edge as I cut the pipe flush. Obvoisly it cannot be square with the pipe since ( at the ends ) the pipes are not square.

I guess we have differing opinions as to how big the flair should be.

Messages In This Thread

Hole's in Hull (for handles)
David Cain -- 2/1/1999, 7:49 am
Re: Hole's in Hull (for handles)
Paul Lund -- 2/2/1999, 3:58 am
Re: Hole's in Hull (for handles)
Preston Seu -- 2/2/1999, 12:16 am
2nd vote for the pipe lining solution
Pete Ford -- 2/1/1999, 5:27 pm
Re: Hole's in Hull (for handles)
Lee -- 2/1/1999, 2:28 pm
Re: Hole's in Hull (for handles)
Nolan Penney -- 2/1/1999, 1:42 pm
Re: Hole's in Hull (for handles)
Jerry Weinraub -- 2/2/1999, 6:55 am
Re: Hole's in Hull (for handles)
Nolan Penney -- 2/3/1999, 1:47 pm
Basically
Brian T. Cunningham -- 2/3/1999, 3:01 pm
line the holes with copper pipe
Brian T. Cunningham -- 2/1/1999, 12:18 pm
Re: Hole's in Hull (for handles)
Jay Babina -- 2/1/1999, 10:15 am