The Kayak Forum is Sponsored By
|
|
|
| |
Kayak Building Bulletin Board
Re: Strip: Ideal table saw setup for cutting strip
Posted By: John Boegman
Date: Sunday, 26 August 2007, at 12:32 a.m.
FYI: I've tried your site on two separate occasions, but I don't find any link at the bottom of the page -- just a couple of icons where something failed to load.
: There is an article on my website about making strips. Basically, I use two
: thin kerf blades and gang cut two at a time. Then the strips are planed to
: 0.250, and bead and cove edges are routed. The article is highly detailed,
: and is essentially a chapter from Building an Adirondack Guideboat. Click
: on the link below, scroll down to the bottom of the page and double click
: My Web site. Then click Builder's Corner for a list of articles, including
: Making Strips.: - John
| |
Kayak Building Bulletin Board is maintained by Nick Schade - Guillemot Kayaks with WebBBS 5.12.
|
|
|
