Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Maroske fittings
In Response To: Re: Material: Maroske fittings ()

I'm guessing some plastics might stick to epoxy, but I never had a problem with the ice tray molds. It is more that vacuum power will stop them from wanting to come off. You have to lever up an edge and let air in.

I have a perfect ice tray for maroskes which I cut up for molds. Perfect size and shape. I drilled 1/4 inch holes in the deepest part of the molds to allow excess epoxy mix out. I keep looking for more of the same shape, but so far have had no luck, even online.

Et