Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Cutting coves by hand is a PITA
By:Bill Hamm
Date: 4/12/2014, 8:00 am
In Response To: Re: Strip: Cutting coves by hand is a PITA (pre-bevelled)

Actually not that hard. Just cut all the strips double width the first time, then when you have all of them cut, set the table saw to 3 degrees and cut the double wide strips in half, the resulting strips both sides will now have a 3 degree bevel on one side and a 90 degree cut on the other.

Bill H.

Messages In This Thread

Strip: Cutting coves by hand is a PITA
Ric Allen -- 4/10/2014, 6:45 pm
Re: Strip: Cutting coves by hand is a PITA
Paul Davies -- 4/10/2014, 7:04 pm
Re: Strip: Cutting coves by hand is a PITA
Etienne Muller -- 4/10/2014, 7:20 pm
Re: Strip: Cutting coves by hand is a PITA
Don T. -- 4/10/2014, 7:54 pm
Re: Strip: Cutting coves by hand is a PITA
pre-bevelled -- 4/11/2014, 2:45 pm
Re: Strip: Cutting coves by hand is a PITA
Marc Upchurch -- 4/11/2014, 5:46 pm
Re: Strip: Cutting coves by hand is a PITA
pre-bevelled -- 4/11/2014, 11:08 pm
Re: Strip: Cutting coves by hand is a PITA
Marc Upchurch -- 4/12/2014, 7:24 am
Re: Strip: Cutting coves by hand is a PITA
Bill Hamm -- 4/12/2014, 8:00 am
Re: Strip: Cutting coves by hand is a PITA
Howie -- 4/11/2014, 6:22 pm
Re: Strip: Cutting coves by hand is a PITA
A. Edie -- 4/11/2014, 9:54 pm
Re: Strip: Cutting coves by hand is a PITA
Etienne Muller -- 4/12/2014, 4:07 am
Re: Strip: Cutting coves by hand is a PITA
Dan Thaler -- 4/12/2014, 9:17 am
Re: Strip: Cutting coves by hand is a PITA
Jay Babina -- 4/12/2014, 8:16 pm