Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Questions
By:Randy Echtinaw
Date: 12/21/2011, 11:05 am

First, what I did/used. Epoxy is 3 months old. I calibrated both pumps to verify a 2:1 pump ratio. The hull was sealed with West epoxy. Heat soaked the shop at 80 degrees for 6 hrs. West epoxy with 206 slow hardener heated to 80 degrees. Poured immediately into a heated, flat pan and applied with West foam rollers.
These questions are based on what I have read here and the results I "expected" to get.
First: I read that epoxy needs to be warm and as thin as water to get a good application and wet-out.
Actuality; the epoxy was thick, like maple syrup, from the very beginning. I could see the epoxy being "stretched" between the wood and roller, very difficult to keep the glass in place. After two filler coats I cannot see the glass so the wet out seems fine but I am stuck with a very textured surface as the epoxy did not seem to flow out very well. Sanding will eliminate this I hope but I may need another filler coat and would like to eliminate the "textured" look.
Second: Apply any reinforcement cloth when the base is no longer tacky and can still be dented with a fingernail. The time frames I have read here are anywhere from 4 to 12 hrs.
Actuality; My 6 oz. cloth was dry and difficult to make a fingernail print in less than 2 1/2 hrs. so I added the 4 oz. cloth over the football area. This makes me very nervous about using the "fast" hardener for fill coats.
The good news is I got a good wet-out as the cloth is gone and I had zero runs, drips or sags which I am sure is due to the thick mixture.
The bad news is, I am sure I have added extra epoxy weight to the boat, created a sanding job for myself and made myself nervous about using "fast" hardener.
So, please tell me what I coulda/shoulda done??
Thank you in advance,
Randy

Messages In This Thread

Strip: Questions
Randy Echtinaw -- 12/21/2011, 11:05 am
Re: Strip: Questions
Rob Macks/Laughing Loon CC&K -- 12/21/2011, 3:23 pm
Re: Strip: Questions
Randy Echtinaw -- 12/21/2011, 9:51 pm
Re: Strip: Questions
Bill Hamm -- 12/22/2011, 1:47 am
Re: Strip: Questions
Rod Tait (Orca Boats) -- 12/21/2011, 5:17 pm
Re: Strip: Questions
Bill Hamm -- 12/22/2011, 1:48 am
Re: Strip: Questions
Randy Echtinaw -- 12/22/2011, 11:27 am
Re: Strip: Questions
Bryan Kapteyn -- 12/22/2011, 3:43 pm
Re: Strip: Questions *PIC*
Etienne Muller -- 12/22/2011, 4:10 pm
Re: Strip: Questions *NM* *PIC*
Etienne Muller -- 12/22/2011, 4:11 pm
Re: Strip: Questions *PIC*
Etienne Muller -- 12/22/2011, 4:12 pm
Re: Strip: Questions *PIC*
Etienne Muller -- 12/22/2011, 4:17 pm