Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: coaming - no lip?
By:Bill Hamm
Date: 9/29/2011, 3:51 pm
In Response To: Re: Strip: coaming - no lip? (Mike Bielski)

: Historic Greenland kayaks do not have a lip. The tuilik was tied to
: the coaming so tightly that it would seal out the water. That's
: one of the reasons why rolling was so important- really hard to
: get out again.

: I would at least put a riser on because it would give you the
: option of using a spray deck of some kind without as great a
: fear of entrapment. IMO- kayaking is WAY more fun when water
: from your paddle isn't running all over your legs every time you
: dip your paddle in the water.

: I really like a composite coaming of some kind- but I didn't like
: all of the steps of "Vaclav's method." On mine I made
: a sacrificial mold of minicell temporarily glued to the hull
: with repositionable spray adhesive, then I covered it with
: aluminum foil I had coated with mold release wax. I used biaxial
: CF tape, when I was done laying it up I pulled the foam away,
: leaving the coaming.

: m

Hi Mike,

I have an untried design for a new easier to make CF coaming, going to try it on Bryan's design this winter. If it works out, I'll show everyone how :)

Bill H.

Messages In This Thread

Strip: coaming - no lip?
Bill VerSteeg -- 9/27/2011, 10:31 am
Re: Strip: coaming - no lip?
Bob Beaullieu -- 9/27/2011, 11:24 am
Re: Strip: coaming - no lip?
Al Edie -- 9/27/2011, 12:00 pm
Re: Strip: coaming - no lip?
Bill VerSteeg -- 9/28/2011, 8:56 am
Re: Strip: coaming - no lip?
Jay Babina -- 9/27/2011, 1:50 pm
Re: Strip: coaming - no lip?
Bill VerSteeg -- 9/28/2011, 8:53 am
Re: Strip: coaming - no lip?
Rob Macks / Laughing Loon CC&K -- 9/27/2011, 2:16 pm
Re: Strip: coaming - no lip?
Mike Bielski -- 9/27/2011, 3:01 pm
Re: Strip: coaming - no lip?
Al Edie -- 9/29/2011, 1:41 pm
Re: Strip: coaming - no lip?
Bill Hamm -- 9/29/2011, 3:51 pm
Re: Strip: coaming - no lip?
Al Edie -- 9/30/2011, 11:28 am
Re: Strip: coaming - no lip?
Bill Hamm -- 10/3/2011, 1:57 am
Re: Strip: coaming - no lip?
Al Edie -- 10/3/2011, 1:56 pm
Re: Strip: coaming - no lip?
Bill Hamm -- 10/4/2011, 2:36 am
Re: Strip: coaming - no lip?
Charles Robinson -- 9/27/2011, 5:39 pm
Re: Strip: coaming - no lip?
Bill Hamm -- 9/28/2011, 2:04 am
Re: Strip: coaming - no lip? *PIC*
Jeff Horton -- 9/28/2011, 2:28 pm
Re: Strip: coaming - no lip?
Bill VerSteeg -- 9/28/2011, 2:37 pm
Re: Strip: coaming - no lip?
Jeff Horton -- 9/28/2011, 4:01 pm
Re: Strip: coaming - no lip?
StephenHJ -- 9/28/2011, 4:24 pm
Re: Strip: coaming - no lip?
Bill Hamm -- 9/29/2011, 2:05 am