Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Seeking: pre-fab coaming
By:fluidpaddler
Date: 8/25/2011, 6:15 am
In Response To: Re: Seeking: pre-fab coaming (mick allen)

Thanks for all the input we have decided the mold will be the way to go.

So brings me to the next question sizing the opening.

I have contacted Seals 'cause we were considering using their spray covers. Didn't get the info i was looking for, on correct sizing. I am assuming they size their covers using the linear circumference of the opening. Not really sure though.

Messages In This Thread

Seeking: pre-fab coaming
fluidpaddler -- 8/24/2011, 1:32 pm
Re: Seeking: pre-fab coaming
Bill Hamm -- 8/24/2011, 3:27 pm
Re: Seeking: pre-fab coaming
Stephen Troy -- 8/24/2011, 8:43 pm
Re: Seeking: pre-fab coaming
Bill Hamm -- 8/24/2011, 10:23 pm
Re: Seeking: pre-fab coaming
Charles Robinson -- 8/24/2011, 4:10 pm
Re: Seeking: pre-fab coaming
fluidpaddler -- 8/24/2011, 4:45 pm
Re: Seeking: pre-fab coaming
StephenHJ -- 8/24/2011, 5:39 pm
Re: Seeking: pre-fab coaming
Bill Hamm -- 8/24/2011, 10:26 pm
Re: Seeking: pre-fab coaming
Jeff Horton -- 8/24/2011, 7:57 pm
Re: Seeking: pre-fab coaming
mick allen -- 8/25/2011, 1:50 am
Re: Seeking: pre-fab coaming
fluidpaddler -- 8/25/2011, 6:15 am
Re: Seeking: pre-fab coaming
Bill Hamm -- 8/25/2011, 7:22 am
Re: Seeking: pre-fab coaming
Reg Lake -- 8/26/2011, 4:20 pm
Re: Seeking: pre-fab coaming
fluidpaddler -- 8/26/2011, 7:42 pm