Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
sanding block
In Response To: Re: Strip: transition from hull to deck? (Jay Babina)
I wanted to add that I use a stanley low angle plane for that.
http://www.google.com/products/catalog?hl=en&q=stanley+low+angle+block+plane&um=1&ie=UTF-8&tbm=shop&cid=12624783491163195299&sa=X&ei=eok-TtXPJZS20AH6oJjsAw&ved=0CCQQ8wIwAA#ps-sellers
Plus I make a sanding board that's around 2 1/2" wide x 12" or so and have 80 grit sand belt material glued on it. It's a good tool to fine tune the joints and smooth out the rolling bevel transitions.
Messages In This Thread
- Strip: transition from hull to deck? *PIC*
Andrew T -- 8/6/2011, 6:07 pm- Re: Strip: transition from hull to deck?
Robin Boys -- 8/6/2011, 6:30 pm- Re: Strip: transition from hull to deck? *PIC*
Kurt Maurer -- 8/6/2011, 6:52 pm
- Re: Strip: transition from hull to deck?
Jay Babina -- 8/7/2011, 7:57 am- Re: Strip: transition from hull to deck?
george jung -- 8/7/2011, 8:06 am- sanding block
Jay Babina -- 8/7/2011, 8:52 am- Re: sanding block
Andrew T -- 8/7/2011, 11:03 am
- sanding block
- Re: Strip: transition from hull to deck? *PIC*
Joy -- 8/7/2011, 11:17 am- Re: Strip: transition from hull to deck?
Kurt Maurer -- 8/7/2011, 7:11 pm- filling the cracks
Jay Babina -- 8/8/2011, 8:19 am
- filling the cracks
- Re: Strip: transition from hull to deck? *PIC*
- Re: Strip: transition from hull to deck?
