Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Off Topic: Bulkhead for existing kayak
By:Rob Hallett
Date: 7/7/2011, 4:14 pm

Pat,

I have never done this but have an idea. If you can reach the forward bulkhead location from the cockpit, I think I would start with a piece of styrafoam -the old slightly crushable and crumbly kind. To get something stable I think you will need something at least an inch thick. Cut a couple holes in the center so you have something to grab to get it back out. I would cut he styrafoam bulkhead a rough slightly oversize shape then press it into place. It will crush against the inside of the hull and get you really close to a bulkhead pattern. You can easilly rasp it into shape if you dont get the fit right on the first try.

Once you have the styrafoam fitting well you can transfer the pattern to something thinner and harder to refine your bulkhead pattern.

Rob

: Hi
: I recently purchased a kayak but it has only one bulkhead and
: wanted to install a fwd bulkhead. In order to get a sizing for
: the bulkhead I marked the outside of the hull at the place where
: the bulkhead was to go with 1" intervals and using a spirit
: level measured from the level to the hull at the intervals.
: Results of the plot were poor so thought I'd see if anybody had
: good way of going about this!
: Many thanks
: Pat

Messages In This Thread

Off Topic: Bulkhead for existing kayak
Pat -- 7/7/2011, 1:00 pm
Re: Off Topic: Bulkhead for existing kayak
ancient kayaker -- 7/7/2011, 2:14 pm
Re: Off Topic: Bulkhead for existing kayak
StephenHJ -- 7/7/2011, 2:42 pm
Re: Off Topic: Bulkhead for existing kayak
David Bynoe -- 7/7/2011, 3:11 pm
Re: Off Topic: Bulkhead for existing kayak
Mike Savage -- 7/7/2011, 6:19 pm
Re: Off Topic: Bulkhead for existing kayak
David Bynoe -- 7/8/2011, 10:35 am
Re: Off Topic: Bulkhead for existing kayak
Bill Hamm -- 7/8/2011, 6:21 am
Re: Off Topic: Bulkhead for existing kayak
Deano -- 7/8/2011, 9:14 am
Re: Off Topic: Bulkhead for existing kayak
Reg Lake -- 7/7/2011, 4:03 pm
Re: Off Topic: Bulkhead for existing kayak
Steve Hill -- 7/7/2011, 4:39 pm
Re: Off Topic: Bulkhead for existing kayak
george jung -- 7/9/2011, 12:05 am
Re: Off Topic: Bulkhead for existing kayak
Rob Hallett -- 7/7/2011, 4:14 pm
Re: Off Topic: Bulkhead for existing kayak
ancient kayaker -- 7/7/2011, 6:53 pm
Re: Off Topic: Bulkhead for existing kayak
Bill Hamm -- 7/8/2011, 6:24 am
Re: Off Topic: Bulkhead for existing kayak
Mike Savage -- 7/7/2011, 6:28 pm
Re: Off Topic: Bulkhead for existing kayak
Pat -- 7/8/2011, 4:45 am
Interesting little challenge
Jay Babina -- 7/8/2011, 7:57 am
Re: Interesting little challenge
Dave Houser -- 7/8/2011, 3:12 pm
Re: Off Topic: Bulkhead for existing kayak
JohnK -- 7/8/2011, 9:31 pm