Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Old epoxy never dies
By:Bill Hamm
Date: 6/24/2011, 7:52 am
In Response To: Re: Material: Old epoxy never dies (Matthew Bastian)

: Jay,

: My local epoxy expert at work has told me its best to boil the
: resin to "recondition" it. The resin turns all white
: and crystalline due to absorbing moisture from the air. When you
: just heat it up the moisture is till in the resin and will
: effect the chemistry to some degree. Boiling for 10 minutes will
: evaporate the moisture completely. He's reconditioned lots of
: epoxy this way and has done so for me. You don't want the boil
: to be too vigorous either as you will start boiling off VOC's in
: the epoxy.

: Don't do this in the same microwave/oven you heat up your lunch in!

: Matthew

Normally the boiling is done while the epoxy is in it's orriginal container, that's placed into a pan of water and the whole thing is brought to a boil. Nice thing about boiling is it's a controlled temperature, at sea level it'll always be 212 degrees F. or 100 degrees C.

Done this way you can't boil off anything from the can, it's contained, though having the cap on loosely is a really good idea :)

Bill H.

Messages In This Thread

Material: Old epoxy never dies
Jay Babina -- 6/22/2011, 6:30 am
Re: Material: Old epoxy never dies
Malcolm Schweizer -- 6/22/2011, 3:32 pm
Re: Material: Old epoxy never dies
Kurt Maurer -- 6/22/2011, 7:41 pm
Re: Material: Old epoxy never dies
Matthew Bastian -- 6/23/2011, 4:06 pm
Re: Material: Old epoxy never dies
Jay Babina -- 6/24/2011, 7:32 am
Re: Material: Old epoxy never dies
Matthew Bastian -- 6/29/2011, 10:55 am
Re: Material: Old epoxy never dies
Bill Hamm -- 6/24/2011, 7:52 am