Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: planed hole in hull
By:Farback
Date: 2/26/2011, 10:59 am
In Response To: Strip: planed hole in hull *PIC* (Eric Anderson)

: I did a rotten job of cove and beading (too shallow a cove) and the
: result was a lot of gaps between strips. The end result was I
: had to do a lot of planing that resulted in a hole (see below).
: My thought is to cut portions of the strips out around this area
: and place new pieces into the resulting area much like you would
: do in fitting the closing strip. I would just cut along the
: grain, cutting out a couple of strips. The part I am not sure of
: is the crosscut. I have just about any tool needed and I am
: thinking of using an exacto knife to cut accross the grain on a
: slight bevel.

: Any comments? (Besides the one I would make which would be
: "Why the heck did you keep going when you must have seen
: that the gaps were too large???")

Why the heck did you... Sorry, too easy. I't going to be tough to grain match, but what I'd do, in my infinite one strip boat wisdom, is cut a long two arc piece, point at both ends, long arcs, about 1.5 strips max width, and bevel slightly so it's bigger on the outside. Should not look too glaringly as a patch.

Kirk

Messages In This Thread

Strip: planed hole in hull *PIC*
Eric Anderson -- 2/26/2011, 10:21 am
Re: Strip: planed hole in hull
Farback -- 2/26/2011, 10:59 am
Re: Strip: planed hole in hull
Bill Hamm -- 2/27/2011, 12:26 am
Re: Strip: planed hole in hull
Mark Seilis -- 2/26/2011, 11:05 am
Re: Strip: planed hole in hull
Mike Bielski -- 2/26/2011, 12:27 pm
Re: Strip: planed hole in hull *PIC*
Eric Anderson -- 2/26/2011, 2:17 pm
Re: Strip: planed hole in hull
Mike Bielski -- 2/26/2011, 3:46 pm
Re: Strip: planed hole in hull
thomas duncan -- 2/27/2011, 8:46 am
Re: Strip: planed hole in hull
Mike Bielski -- 2/27/2011, 12:59 pm
Re: Strip: planed hole in hull
Bill Hamm -- 2/28/2011, 12:17 am
Re: Strip: planed hole in hull
Mike Bielski -- 2/28/2011, 8:23 am
Re: Strip: planed hole in hull
Bill Hamm -- 3/1/2011, 2:14 am
Re: Strip: planed hole in hull
Mike Bielski -- 3/1/2011, 7:57 am
Re: Strip: planed hole in hull
Paul G. Jacobson -- 2/26/2011, 7:47 pm
Re: Strip: planed hole in hull
JohnK -- 2/26/2011, 4:07 pm
Re: Strip: planed hole in hull
ancient kayaker -- 2/26/2011, 11:41 pm
Re: Strip: planed hole in hull
Bill Hamm -- 2/27/2011, 12:27 am