Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Off Topic: Rolling
By:Les Cheeseman
Date: 1/20/2011, 4:27 pm

I know this is hardly building related but there seems little action in other parts of the forum.
When (a long time aqgo) I was a strip of a lad, I built a couple of SOF boats and did a load of white water (river) kayaking.
I was taught back then to roll by leaning forewards over the deck and sweeping the paddle from the bow.
Since I have been on the forum, I have never seen reference to anything other than layback rolling.
I know that you guys are all pretty laid back but is the lay back method so much better (don't say ask the wife!)
Should I be trying this method against what I am used to (45 years ago). I may be old but I'll try anything once.
What are the pros and cons?
Les C

Messages In This Thread

Off Topic: Rolling
Les Cheeseman -- 1/20/2011, 4:27 pm
Re: Off Topic: Rolling
Stephen Troy -- 1/20/2011, 4:52 pm
Re: Off Topic: Rolling
JohnK -- 1/20/2011, 5:38 pm
Re: Off Topic: Rolling
Dave Gentry -- 1/20/2011, 8:19 pm
Re: Off Topic: Rolling
Rob Macks / Laughing Loon CC&K -- 1/21/2011, 10:51 am
Re: Off Topic: Rolling
Les Cheeseman -- 1/21/2011, 11:28 am
Re: Off Topic: Rolling
Mike Bielski -- 1/21/2011, 1:42 pm
Go Mike (Again)
Kurt Maurer -- 1/21/2011, 7:20 pm
Re: Off Topic: Rolling
Dave Gentry -- 1/21/2011, 2:17 pm
Re: Off Topic: Rolling
Roy Martin (fadedred) -- 1/21/2011, 9:51 pm
Re: Off Topic: Rolling
Bill Hamm -- 1/22/2011, 1:04 am
Re: Off Topic: Rolling
Roy Martin (fadedred) -- 1/22/2011, 8:32 pm
Re: Off Topic: Rolling
Bill Hamm -- 1/23/2011, 12:28 am
Re: Off Topic: Rolling
Bill Hamm -- 1/23/2011, 9:03 am
Re: Off Topic: Rolling
Dave Gentry -- 1/23/2011, 10:04 am
Re: Off Topic: Rolling
Bill Hamm -- 1/23/2011, 3:33 pm
Re: Off Topic: Rolling
Bill Hamm -- 1/21/2011, 3:14 pm
Re: Off Topic: Rolling
Len Thunberg -- 1/28/2011, 11:24 pm
Re: Off Topic: Rolling
Rob Macks / Laughing Loon CC&K -- 1/29/2011, 10:28 am
Re: Off Topic: Rolling
Eric -- 1/21/2011, 12:08 pm