Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Alternate option...
By:Oliver Bloch
Date: 1/12/2011, 7:59 am
In Response To: Re: Alternate option... (Sean mcgrath)

: I was thinking the same thing Tim, but does it matter? Can't strips
: be whatever width you want? I'm a noob about to start my first
: boat, so I'm curious.

Absolutely, the limiting factor being the amount of curvature you need to accommodate across the width of the strip, so on a flat section of the deck (down the centerline, perhaps) or along a hard chine, it's not a problem.

Messages In This Thread

Strip: Ripping 2x12s into strips
Stephen Troy -- 1/11/2011, 10:42 pm
Alternate option...
Stephen Troy -- 1/11/2011, 11:40 pm
Re: Alternate option...
Tim Sheehan -- 1/12/2011, 12:23 am
Re: Alternate option...
Allan -- 1/12/2011, 2:26 am
Re: Alternate option...
Sean mcgrath -- 1/12/2011, 7:45 am
Re: Alternate option...
Oliver Bloch -- 1/12/2011, 7:59 am
Re: Alternate option...
Tim Sheehan -- 1/12/2011, 10:30 am
Re: Alternate option...
paul davies nz -- 1/12/2011, 1:46 pm
Re: Alternate option...
Al Edie -- 1/13/2011, 12:19 pm
Re: Alternate option...
Bill Hamm -- 1/13/2011, 2:09 pm
Re: Alternate option...
Al Edie -- 1/13/2011, 4:29 pm
Re: Alternate option...
Bill Hamm -- 1/13/2011, 6:53 pm