Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Standard coming lip height and width?
By:Dave Houser
Date: 1/11/2011, 2:33 pm
In Response To: Strip: Standard coming lip height and width? (Todd O)

3/4" clear high and 3/4" overhang. If your skirt or cover has a knotted bungee it takes all 3/4" of height for the knot to fit under the overhang.

: Soon I'll be working on laminating a coming lip on my already
: existing coming riser. Is there a standard height (distance
: between top of deck and bottom of lip), and width (distance from
: outside of coming riser to outside of lip) to keep a spray skirt
: on well? Also; where do most get their wood for this? I've been
: searching for Ash Veneer, but it's all too thin, and often has
: paper on one side, etc. Is there someplace that sells like 1/8
: inch ash veneer, or should I just plan on sawing my own?

: Thanks,
: Todd

Messages In This Thread

Strip: Standard coming lip height and width?
Todd O -- 1/11/2011, 1:43 pm
Re: Strip: Standard coming lip height and width? *PIC*
Joe Whitman -- 1/11/2011, 2:18 pm
Re: Strip: Standard coming lip height and width?
Joe Whitman -- 1/11/2011, 2:25 pm
Re: Strip: Standard coming lip height and width?
John Caldeira -- 1/11/2011, 2:24 pm
Re: Strip: Standard coming lip height and width?
Dave Houser -- 1/11/2011, 2:33 pm
Re: Strip: Standard coming lip height and width? *PIC*
Clayton Plunkett -- 1/11/2011, 2:58 pm
Re: Strip: Standard coming lip height and width? *PIC*
Ian Cummins -- 1/11/2011, 4:38 pm
Re: Strip: Standard coming lip height and width? *PIC*
Kurt Maurer -- 1/11/2011, 7:24 pm
Re: Strip: Standard coming lip height and width?
Bill Hamm -- 1/12/2011, 12:39 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:29 am
Re: Strip: Standard coming lip height and width? *NM* *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:30 am
Re: Strip: Standard coming lip height and width? *NM* *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:31 am
Re: Strip: Standard coming lip height and width?
Todd O -- 1/12/2011, 10:00 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/13/2011, 7:13 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/13/2011, 7:16 am
Re: Strip: Standard coming lip height and width?
Bill Hamm -- 1/13/2011, 8:59 am