Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Standard coming lip height and width?
By:John Caldeira
Date: 1/11/2011, 2:24 pm
In Response To: Strip: Standard coming lip height and width? (Todd O)

Standard height (distance between top of deck and bottom of lip) = 3/4 inch

Width (distance from outside of coming riser to outside of lip) = 3/4 inch

I saw my own wood strips for the coaming lip. Now I only have a circular saw, but I clamp a piece of wood to the underside as a guide to slice off strips slightly thinner than 1/8 inch.

John

Messages In This Thread

Strip: Standard coming lip height and width?
Todd O -- 1/11/2011, 1:43 pm
Re: Strip: Standard coming lip height and width? *PIC*
Joe Whitman -- 1/11/2011, 2:18 pm
Re: Strip: Standard coming lip height and width?
Joe Whitman -- 1/11/2011, 2:25 pm
Re: Strip: Standard coming lip height and width?
John Caldeira -- 1/11/2011, 2:24 pm
Re: Strip: Standard coming lip height and width?
Dave Houser -- 1/11/2011, 2:33 pm
Re: Strip: Standard coming lip height and width? *PIC*
Clayton Plunkett -- 1/11/2011, 2:58 pm
Re: Strip: Standard coming lip height and width? *PIC*
Ian Cummins -- 1/11/2011, 4:38 pm
Re: Strip: Standard coming lip height and width? *PIC*
Kurt Maurer -- 1/11/2011, 7:24 pm
Re: Strip: Standard coming lip height and width?
Bill Hamm -- 1/12/2011, 12:39 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:29 am
Re: Strip: Standard coming lip height and width? *NM* *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:30 am
Re: Strip: Standard coming lip height and width? *NM* *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:31 am
Re: Strip: Standard coming lip height and width?
Todd O -- 1/12/2011, 10:00 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/13/2011, 7:13 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/13/2011, 7:16 am
Re: Strip: Standard coming lip height and width?
Bill Hamm -- 1/13/2011, 8:59 am