Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Quick questions on wood selection
By:Scott Fitzgerrell
Date: 10/8/2010, 2:44 am
In Response To: Strip: Quick questions on wood selection (tosetter)

: I ordered WRC from a local lumber yard that had to have it
: delivered in from a regional supplier. What I ordered was 1 x 6
: S4S. When I placed the order, the guy at the desk confrimed that
: it would be 3/4 x 5 1/2 inches. Well I picked it up today, and
: it looked great all bundled up. When I got home I realized that
: it's only finished on 3 sides; not 4 as agreed, and its already
: down to 5/8 inch thick instead of 3/4. If I were to finish the
: 4th side (don't currently have a way to do it), it'd be closer
: to 1/2 inch thick. What would you do? Bring it back and hope
: that they can get stuff actually finished on 4 sides and 3/4
: inch thick, or just deal with what they gave me? If I decide to
: just deal with it, does anyone know of a practical way of
: finishing that 4th side without going out and buying a planer?
: It's the wide 5.5 inch side that's unfinished, so I was
: wondering if maybe I rip the strips, and somehow plane them in
: strip form, but this seems like it would be an awful lot of
: work. I should also add that I don't plan on bead and cove,
: otherwise I could shave off the unfinished side when creating
: the cove. Since this stuff is already down to 5/8 though, if I
: go bead and cove, I won't have much left to work with.....

: Comments appreciated

: Thanks,

: TO

I've done two strippers and a hybrid with cedar just like yours. I just set a five-degree bevel on the tablesaw and ran the strips through, taking off the fuzzy edge. I then built the boats virtually without hand-planing, and the joints came out nice and tight. For flat sections, you can interlock the beveled edges; this happens typically near the keel on the hull, and the back deck of some designs. I've found this to be a very flexible, non-fussy way to go.

--S

Messages In This Thread

Strip: Quick questions on wood selection
tosetter -- 10/7/2010, 9:03 pm
Re: Strip: Quick questions on wood selection
Randy Echtinaw -- 10/11/2010, 6:03 am
Re: Strip: Quick questions on wood selection
Jay Babina -- 10/8/2010, 9:14 am
Re: Strip: Quick questions on wood selection
Bill Hamm -- 10/9/2010, 12:29 am
Re: Strip: Quick questions on wood selection
tosetter -- 10/8/2010, 10:49 am
Re: Strip: Quick questions on wood selection
Dean -- 10/8/2010, 8:21 am
Re: Strip: Quick questions on wood selection
Brian Nystrom -- 10/8/2010, 7:22 am
Re: Strip: Quick questions on wood selection
Scott Fitzgerrell -- 10/8/2010, 2:44 am
Re: Strip: Quick questions on wood selection
Bill Hamm -- 10/8/2010, 2:05 am
Re: Strip: Quick questions on wood selection
Tim Sheehan -- 10/8/2010, 12:13 am
Re: Strip: Quick questions on wood selection *PIC*
G New -- 10/7/2010, 9:41 pm
Re: Strip: Quick questions on wood selection
Oliver Bloch -- 10/7/2010, 9:39 pm
Re: Strip: Quick questions on wood selection
Joy -- 10/8/2010, 7:50 am