Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Routing bead and cove
By:Deano
Date: 10/2/2009, 12:53 pm
In Response To: Strip: Routing bead and cove (Mrkim)

I agree with Bill. Feeding stock into a power tool with the direction of rotation as opposed to against it is unsafe. It can result in the piece being snatched from your hand and shot into the opposite wall. Think about it, that's exactly how pitching machines work.

Messages In This Thread

Strip: Routing bead and cove
Mrkim -- 10/2/2009, 9:01 am
Re: Strip: Routing bead and cove
JohnK -- 10/3/2009, 4:43 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/4/2009, 12:22 am
Re: Strip: Routing bead and cove
JohnK -- 10/5/2009, 12:36 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/6/2009, 2:12 am
Re: Strip: Routing bead and cove
Deano -- 10/2/2009, 12:53 pm
Re: Strip: Routing bead and cove
Ken Blanton -- 10/2/2009, 5:27 pm
wrong is sometime right..
Larry C. -- 10/2/2009, 6:16 pm
Re: wrong is sometime right..
Mrkim -- 10/3/2009, 12:03 am
Re: Strip: Routing bead and cove
Wesley Ewell -- 10/2/2009, 1:18 pm
.02 cents from a former machinist
Reg Lake -- 10/3/2009, 12:56 am
Re: Strip: Routing bead and cove
Etienne Muller -- 10/2/2009, 2:16 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 4:27 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 10:35 am
Re: Strip: Routing bead and cove
Paul G. Jacobson -- 10/2/2009, 9:23 am