Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Surface finish for performance
By:Craig Robinson
Date: 6/13/2009, 2:01 am

: I go back to sailboat racing experience, generally find that a slightly
: roughened surface, actually like a mat painted surface, tends to have
: slightly less drag than a polished one. Usually obtained by sanding with
: like 320 - 400 grit sanded wet.

: Dolphins also have a odd skin that gives to allow better flow, impossible to
: duplicate though.

: Bill H.

Bill, when i run my fingers over a smooth high gloss finish it feels a bit "grabbier" than a surface that has been sanded with fine grit wet n'dry like you mentioned. I can't suport it with any science though.
Cheers, Boof

Messages In This Thread

Material: Surface finish for performance
Craig Robinson -- 6/12/2009, 2:38 am
Re: Material: Surface finish for performance
Don Lucas -- 6/14/2009, 1:57 pm
Re: Material: Surface finish for performance
Bill Hamm -- 6/13/2009, 1:14 am
Re: Material: Surface finish for performance
Craig Robinson -- 6/13/2009, 2:01 am
Re: Material: Surface finish for performance *LINK*
Aaron H -- 6/12/2009, 12:46 pm
Re: Material: Surface finish for performance
Michael Collins -- 6/13/2009, 5:57 pm
Re: Material: Surface finish for performance
Bill Hamm -- 6/14/2009, 12:47 am