Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Shop: correcting lee cocking
By:Reg Lake
Date: 5/5/2008, 3:31 pm
In Response To: Shop: correcting lee cocking (PatrickC)

How about 1/10 the current distance forward at 10X the weight, etc. Of course this only works if you weigh 150 lbs.

Reg

: so i put a 15lb dumbell as far forward in my bow as i could get it
: and it eliminated all lee cocking and increased stability.

: Question is..anyone have a good guesstimate of how far forward i need to move
: my seat to simulate a 15 lb increase at the bow tip(15" back from bow
: tip.)

: and is there a good physical method to determine said..

: i'm thinking put the boat on a see saw..get in...slide forward til the bow
: gets 15 lbs heavier.

Messages In This Thread

Shop: correcting lee cocking
PatrickC -- 5/5/2008, 2:07 pm
Re: Shop: correcting lee cocking
Dave Houser -- 5/8/2008, 12:32 am
Re: Shop: correcting lee cocking
PatrickC -- 5/8/2008, 5:46 pm
Re: Shop: correcting lee cocking
Bill Hamm -- 5/11/2008, 2:06 am
Re: Shop: correcting lee cocking
Dave Houser -- 5/8/2008, 11:57 pm
Re: Shop: correcting lee cocking
Mike Savage -- 5/5/2008, 7:02 pm
Re: Shop: correcting lee cocking..It Works
PatrickC -- 5/5/2008, 9:33 pm
Re: Shop: correcting lee cocking..It Works
Bill Hamm -- 5/6/2008, 12:52 am
Re: Shop: correcting lee cocking.Final conclusion
PatrickC -- 5/7/2008, 11:09 pm
Re: Shop: correcting lee cocking.Final conclusion
Paul G. Jacobson -- 5/8/2008, 7:22 pm
Re: Shop: correcting lee cocking.Final conclusion
Bill Hamm -- 5/8/2008, 12:47 am
Re: Shop: correcting lee cocking..It Works
PatrickC -- 5/6/2008, 1:08 am
Re: Shop: correcting lee cocking
PatrickC -- 5/5/2008, 7:23 pm
Re: Shop: correcting lee cocking
PatrickC -- 5/5/2008, 7:07 pm
Re: Shop: correcting lee cocking
Reg Lake -- 5/5/2008, 3:31 pm
Re: Shop: correcting lee cocking
PatrickC -- 5/5/2008, 4:06 pm
Re: Shop: correcting lee cocking
Reg Lake -- 5/5/2008, 4:45 pm
Re: Shop: correcting lee cocking
Bill Hamm -- 5/6/2008, 12:49 am