Re: Paddle: Planing to build a paddle, am I on the
In Response To: Paddle: Planing to build a paddle, am I on the right track (JJ Atkinson)
:JJ an angle grinder with a sandpaper adapter will save a lot of time shaping. If you just fiberglass 4 inches on the tip on one side of the paddle it will make it lighter. If you let the fiberglass hang about 1/2 inch over the tip of the paddle and run a bead of thick epoxy around the tip on the back side of the glass it will make a rock guard (trim it after it has cured). Most of all have fun
Messages In This Thread
- Paddle: Planing to build a paddle, am I on the right track
JJ Atkinson -- 3/29/2003, 2:15 pm- Re: Paddle: Planing to build a paddle, am I on the
Rich D -- 3/30/2003, 10:28 pm- Re: Paddle: Planing to build a paddle, am I on the
Scott Baxter -- 3/30/2003, 12:41 pm- Re: Paddle: Planing to build a paddle, am I on the *Pic*
Chip Sandresky -- 3/29/2003, 10:37 pm - Re: Paddle: Planing to build a paddle, am I on the
- Re: Paddle: Planing to build a paddle, am I on the